Posted: June 16th, 2005, 5:26 pm
After getting a sun tan in wee Alberta, nice place by the way,
back home to the cold, well chills to you harden lot...
Making the butterfly for a over sized TB is easy, you don't turn a true
round plate, but offsett a brass sheet at about 10-15 degrees in a
jig and them turn it so the edges seat on the bore, getttng the right
angle is a wee bit trial and error, as long as you can reset the TPS
its not so critiacal.....
Matt.....
back home to the cold, well chills to you harden lot...
Making the butterfly for a over sized TB is easy, you don't turn a true
round plate, but offsett a brass sheet at about 10-15 degrees in a
jig and them turn it so the edges seat on the bore, getttng the right
angle is a wee bit trial and error, as long as you can reset the TPS
its not so critiacal.....
Matt.....