I did, yea.. and it certainly helped. The problem is I was working in the dark with only a handheld fluorescent light.... I couldn't see what I was doing.Daninski wrote:You said you had a few runs. Did you do a light tack coat first to give the paint a base to adhere to?
"It'll look good!"
Re: "It'll look good!"
- Gord
1996 MX-3 GS-ZE 2.5L 5spd
KLZE+LSD / Headers / KL02 VAF / Clutchmasters stage-I / Fidanza 9lb flywheel / Eibach Pro Kit / Tokico HPs / Urethane bushings & mounts / SSR Comp-C 16x7 / General Exclaim UHP 205/45R16 / Wilwood 13" brakes / Whiteline rear swaybar / Carputer / Software Crossover / Infinity components+subs / 41hz Tripath Amp9 / Trunk SLA batt / Keyless entry
1996 MX-3 GS-ZE 2.5L 5spd
KLZE+LSD / Headers / KL02 VAF / Clutchmasters stage-I / Fidanza 9lb flywheel / Eibach Pro Kit / Tokico HPs / Urethane bushings & mounts / SSR Comp-C 16x7 / General Exclaim UHP 205/45R16 / Wilwood 13" brakes / Whiteline rear swaybar / Carputer / Software Crossover / Infinity components+subs / 41hz Tripath Amp9 / Trunk SLA batt / Keyless entry
Re: "It'll look good!"
Well here's an emo shot of my respray:

There are some runs and a couple orange peel areas I'll have to sand out, but the paint's not completely cured yet. All in all, a definite improvement. But god painting's hard.
I still have to do the hatch and the bumpers/fenders, but I'll do that when I replace them.

There are some runs and a couple orange peel areas I'll have to sand out, but the paint's not completely cured yet. All in all, a definite improvement. But god painting's hard.
I still have to do the hatch and the bumpers/fenders, but I'll do that when I replace them.
- Gord
1996 MX-3 GS-ZE 2.5L 5spd
KLZE+LSD / Headers / KL02 VAF / Clutchmasters stage-I / Fidanza 9lb flywheel / Eibach Pro Kit / Tokico HPs / Urethane bushings & mounts / SSR Comp-C 16x7 / General Exclaim UHP 205/45R16 / Wilwood 13" brakes / Whiteline rear swaybar / Carputer / Software Crossover / Infinity components+subs / 41hz Tripath Amp9 / Trunk SLA batt / Keyless entry
1996 MX-3 GS-ZE 2.5L 5spd
KLZE+LSD / Headers / KL02 VAF / Clutchmasters stage-I / Fidanza 9lb flywheel / Eibach Pro Kit / Tokico HPs / Urethane bushings & mounts / SSR Comp-C 16x7 / General Exclaim UHP 205/45R16 / Wilwood 13" brakes / Whiteline rear swaybar / Carputer / Software Crossover / Infinity components+subs / 41hz Tripath Amp9 / Trunk SLA batt / Keyless entry
-
- Regular Member
- Posts: 1083
- Joined: August 23rd, 2008, 12:09 am
- Location: Beamsville.
Re: "It'll look good!"
lol i sort of enjoyed my car when it was a bondo buggy, blue door purple bumper mx3. especially when it was completely sanded down before paint. it was a total sleeper. 

NEED PARTS INSTALLED? PM ME!


Re: "It'll look good!"
Ya you know it wasn't the work that was getting to me .. it was actually kinda fun... the problem was I was doing this all in a parking garage and I knew at any moment all hell could break loose and the building owner would fly off the handle... which he did, right after I finished my last coat.projectzemx3 wrote:lol i sort of enjoyed my car when it was a bondo buggy, blue door purple bumper mx3. especially when it was completely sanded down before paint. it was a total sleeper.

I was always working under a frustrating time pressure, and learning at the same time. Bad combination.
- Gord
1996 MX-3 GS-ZE 2.5L 5spd
KLZE+LSD / Headers / KL02 VAF / Clutchmasters stage-I / Fidanza 9lb flywheel / Eibach Pro Kit / Tokico HPs / Urethane bushings & mounts / SSR Comp-C 16x7 / General Exclaim UHP 205/45R16 / Wilwood 13" brakes / Whiteline rear swaybar / Carputer / Software Crossover / Infinity components+subs / 41hz Tripath Amp9 / Trunk SLA batt / Keyless entry
1996 MX-3 GS-ZE 2.5L 5spd
KLZE+LSD / Headers / KL02 VAF / Clutchmasters stage-I / Fidanza 9lb flywheel / Eibach Pro Kit / Tokico HPs / Urethane bushings & mounts / SSR Comp-C 16x7 / General Exclaim UHP 205/45R16 / Wilwood 13" brakes / Whiteline rear swaybar / Carputer / Software Crossover / Infinity components+subs / 41hz Tripath Amp9 / Trunk SLA batt / Keyless entry
- _-Night-Shade-_
- Senior Member
- Posts: 2664
- Joined: January 15th, 2009, 8:00 pm
- Location: Toronto, Ontario, Canada
Re: "It'll look good!"
Holy s---, that is a definite improvement!
Re: "It'll look good!"
Thanks!_-Night-Shade-_ wrote:Holy s---, that is a definite improvement!

Next up:

This should be a lot easier to paint since I can do it on my balcony during the day instead of in a dark garage.
- Gord
1996 MX-3 GS-ZE 2.5L 5spd
KLZE+LSD / Headers / KL02 VAF / Clutchmasters stage-I / Fidanza 9lb flywheel / Eibach Pro Kit / Tokico HPs / Urethane bushings & mounts / SSR Comp-C 16x7 / General Exclaim UHP 205/45R16 / Wilwood 13" brakes / Whiteline rear swaybar / Carputer / Software Crossover / Infinity components+subs / 41hz Tripath Amp9 / Trunk SLA batt / Keyless entry
1996 MX-3 GS-ZE 2.5L 5spd
KLZE+LSD / Headers / KL02 VAF / Clutchmasters stage-I / Fidanza 9lb flywheel / Eibach Pro Kit / Tokico HPs / Urethane bushings & mounts / SSR Comp-C 16x7 / General Exclaim UHP 205/45R16 / Wilwood 13" brakes / Whiteline rear swaybar / Carputer / Software Crossover / Infinity components+subs / 41hz Tripath Amp9 / Trunk SLA batt / Keyless entry
- mx-3_4evr
- Regular Member
- Posts: 609
- Joined: February 8th, 2008, 12:15 am
- Location: Burnsville,MN
- Contact:
Re: "It'll look good!"
Nice man! I like the Mazdaspeed bumper. Balcony painting FTW! 
