deleting cooling line on pwer steering....
-
PWRD_BY_HKS
- Regular Member
- Posts: 696
- Joined: August 11th, 2004, 2:01 am
- Location: El Paso
deleting cooling line on pwer steering....
so there is a line that comes infront of the ac condensor infront of everything..... it kinda makes a u turn and goes back in... its for power steering... well i had to cut that line and im not too sure how much pressure that line was under... it looks like it was made of copper .... the point is i cut it but i still want my power steering therefore my question is, would a steel braided hose hold the pressure, has anyone done this before?
jdmx-3 KID OF THE 
VICTORIA RACING
ZE PERFORMANCE IN 915 TX
Kl01-ZE,Kl31 ecu, millenia manifold, ngk plugs, ngk wires, probe tranny/ and clutch (stock), VortecH FMU 12:1, Aeromotive AFPR, Tial .38mm Wastegate w/ 4lbs spring, Walboro 255 pump, AiResearch T4, 3" down pipe, GODSPEED manifold, Spearco Boost Gauges, BF Goodrich G-force drag radials.
14.8 1/4 mile all motor untimed on boost.
VICTORIA RACING
ZE PERFORMANCE IN 915 TX
Kl01-ZE,Kl31 ecu, millenia manifold, ngk plugs, ngk wires, probe tranny/ and clutch (stock), VortecH FMU 12:1, Aeromotive AFPR, Tial .38mm Wastegate w/ 4lbs spring, Walboro 255 pump, AiResearch T4, 3" down pipe, GODSPEED manifold, Spearco Boost Gauges, BF Goodrich G-force drag radials.
14.8 1/4 mile all motor untimed on boost.