custom dash piece

ninjajim4 · Post by **ninjajim4** » September 14th, 2007, 7:33 pm

hey guys,

i have a smart cord for my radar detector and i want to put it in the spot in between the power mirror controls and the light dimmer, where ppl put the fog light button when they have it.

i pulled out the blank and took some side by sides with the smart cord controls. as you can see, they're a very close match. i was just looking for suggestions for what to use to fill out the corners and make it look right or what i might use to create a bezel for it. i thought i'd carve up the blank, but it's basically too close a match and i'd end up with almost nothing left of it.

thanks!

Vanished · Post by **Vanished** » September 14th, 2007, 7:36 pm

You can cut a peice of aluminum out (drill and dremmel) , and wrap it with vinyl

A peice of wood wrapped in vinyl

A peice of plastic wrapped in vinyl

A peice of fiberglass wrapped in vinyl

carbon fiber. NOT wrapped in vinyl

haha..lots of choices.

ninjajim4 · Post by **ninjajim4** » September 14th, 2007, 7:39 pm

hrmm.. should i use vinyl?

lol.. nuff said, thanks! didn't occur to me. but i'm not much of a custom fabber.. thanks!

Post by **Mooneggs** » September 17th, 2007, 6:01 pm

that's going to look cool when you get done... post up pics when you have it installed