Millenia ZE intake manifold vacuum line question

David Coleman · Post by **David Coleman** » July 24th, 2002, 1:25 am

So my ZE manifold has the VRIS solenoids bolted to the manifold, side by side. the one closest to the TB has a white sticker on it, and the other one doesnt. Any idea which goes to which plug on the stock harness?

David Coleman · Post by **David Coleman** » July 24th, 2002, 2:47 am

An answer from Tom [precidian]:

ZUNE MX-3 Gs · Post by **ZUNE MX-3 Gs** » July 24th, 2002, 3:41 pm

I would connect it anywhere and run the engine. The Vris program may be similar to the regular Kl one, so looking at what valve opens first you could know what is valve nº1 and valve nº2. I suppose that the only difference are the opening points on the powerband, but the sequence should be the nearly the same.

David Coleman · Post by **David Coleman** » July 24th, 2002, 3:57 pm

Nah, I'll just stick with getting it right the first time

ghandi1981 · Post by **ghandi1981** » July 25th, 2002, 1:46 am

hey david which manifold are u using??? is that like the one i saw on ebay the other day???AJ

Smokin mx-3 · Post by **Smokin mx-3** » July 25th, 2002, 1:50 am

I have this exact same manifold and I have the white connector with the white dot the same way it is in the picture it runs fine

David Coleman · Post by **David Coleman** » July 25th, 2002, 8:56 pm

<BLOCKQUOTE>quote:<HR>Originally posted by ghandi1981: hey david which manifold are u using??? is that like the one i saw on ebay the other day???AJ<HR></BLOCKQUOTE>Curved neck Millenia manifold. Just like the one above.

MX-3.com

Millenia ZE intake manifold vacuum line question

Millenia ZE intake manifold vacuum line question

Re: Millenia ZE intake manifold vacuum line question

Re: Millenia ZE intake manifold vacuum line question

Re: Millenia ZE intake manifold vacuum line question

Re: Millenia ZE intake manifold vacuum line question

Re: Millenia ZE intake manifold vacuum line question

Re: Millenia ZE intake manifold vacuum line question