MX-3.com

I just got done looking at that site at the top its says for the 1.8. I guessing thats a typo?

That engine bay looks puurrddyy. Looks good man

ryanlindenberg wrote:nobody has AWD, so goodluck.

Thats cool and luck has nothing to do with its all skill. As far as my question is concerned did anyone get a tranny with the engine BUT didn't use it and is willing to sell it?

would those axles fit that AWD tranny? and also how many of you guys have that tranny? I'm looking to do a AWD setup on my MX-3

Ok cool i guess I 'll start from there, BTW thanx for all the help. I'll give you guys updates as I go along. And agian thank you

if you are looking for a bolt on turbo manifold why not go for the b6t one
As far as I read from the rest of the forums they can be hard to get a hold of one, please correct me if I'm wrong but the b6t was only on a limited number of 323s. Well let me ask this do the flanges of the miata motor ...

I got a question How did you get those headlights? Or how did you make them if you made them?

I looking at the one from HKS here is the link http://www.hksusa.com/products/?id=657&rsku=5349

Tell me what you think

so if it was going down then it'll work? If so let me know because I might have found one.

wont work. Miata is RWD and MX is FWD. OUr header goes down and the Miata header would go to the side.
I seen both, which is a fine point that been brought to my attention while researching this. It's my fault for not getting specific, I was looking more at the turbo manifolds that go on to the ...

I would first like to say hello, but quick question will a exhaust manifold from a the 1.6 miata fit the DOHC versions of our motor? Or do I have to flip it and drill new holes to make it work?

BTW nice site learned alot already.