MX-3.com

I prefer manual transmission (I have it on my 3000GT VR4), but she wanted an auto mx3 (difficult to faind on Spain; I went to Germany to buy it). The car runs great, but the problem is that the car would need a little more power.

Thanks for your answers.
Regards.

But auto trans was also in MX-3 v6, so it can handle more or less the same power that a B6 turbo??

Hi.

My girlfriend has a '93 Mx-3 1.6 SOCH auto, with a new rebuilt auto transmission and a good cooler for it.

I think that the car needs more power, and I've found an BPturbo from a 323 GT-R and I was wondering if it could fit my MX-3 with the auto trans, and if the trans would support the power ...

Hi all.

Next week I'll receive my ATX rebuilt. I'm also adding a oil cooler, and I would like to know which is the best oil for the atx. Can we put Dexron III or only Dexron II?.

Thanks in advance.

Hi all.

I've found a 323 1.5 (Z5 motor) atx, but from the pictures it seems a little different from the F4AEL Mx3 atx. The wire conectors seem different and so on.

I think it is the FB4AEL and I would like to know if it could fit in my Mx3. The sticker ON IT says F7FW440 TB.

Regards.

I took the factory cooler lines, and no flow goes in them. I think maybe the oil pump is burned or perhaps the shaft doesn't move the oil pump.

I'll take a look at the oil pump and see what is happening.

Regards.

Alex.

Also, I have readen about the oil coolers, and I will place one with a vent when I have my atx reapaired.

Thanks and best regards.

Hi all.

This is my first post, but I use to write in www.3si.org.

My problem is that I have a Mx3 1.6 ATX, and the atx works well, until the car reaches the normal temperature. When this happen, the Hold light begins to blink and the atx gets slippy. I changed the atx oil and filter and no ...