MX-3.com

ttt= to the top

does this also apply to a freshly painted car? just got mine resprayed and now gotta clean it for the first time. what is my best bet?

i hear slapping a bit of transmission fluid on er will have a similar effect

I have a 1991 mazda 323 that I am parting out. Everything is there except the transmission and the distributor/coil. Motor is bad. Interior is in good shape and so is the exterior. Buyer pays shipping from Nova Scotia, Canada. Pictures can be seen at:
323 pictures

Well i think i saved my current tranny by shutting it down as soon as it kicked out of gear. Last night it went up on the hoist and inspected the gears and they appear to still be intact. The fluid level was really low though. Filled it back up with i think 75w80, cant remember right now. Gonna keep ...

Burn out, barely ever and never since my new one less than 1000 kms ago. Yes, i know how to shift and rarely grind a gear. Checked my tranny oil level tonight and it was really low, filled it back up a bit and am gonna drive it into the shop tonight to check all the seals. Any place common where ...

What could be the cause of my car repeatedly having problems with transmissions? I am now on my 3rd tranny since i bought my 92 rs. Is this sohc just too much power for it? I think not. The fluid level seems fine but I just swapped in another one and now its coming out of gear voluntarily again. Bad ...

i believe these trucks have the same body style in 88 and 86 so anything to do with that should be interchangable. I want to get an old 4runner and have researched a lot.

I've been searching for this for a while, does anybody actually know the differences in the gearing between the F series transmission? Specifically a 4cyl mx-3 vs. a 91 323 se. I bought one the other day with plans of putting it's transmission into my 92 Sohc.

anyone pssibly notice a red mx3 in spiderman 2 also?

yeah i looked at it toay, and it was the front cable so i got it for 30 bucks and put it on, not too bad of a job if you move the exhaust piping out of the way. Had to file down the ends on the 2 rear cables so they would fit into the new front cable section.

Just my luck, i tighten it up a bit, and as i pull up the lever to see if it has any effect, SNAP... Well there goes that cable. Time to taker in to the shop I think.

cool thanks alot, i'll have a look at that

close to my gas tank? not really, i am just putting it on the bolts to try and get them loose. But my original question is do i even need to take this off to adjust my parking brake?

how do i go about adjusting my parking brake? Right now my car is sitting up on jackstands with the rear wheels off and trying to get the drum off. I can only get one screw out on eiter side. I'm going to try and heat them up a bit and then try. Do I even need to be inside to tighten up the parking ...