MX-3.com

Hy, i will print every info from here, and i will giv it to a mechanic, maybe then he will make the car work in order. It's imposible to fiind a mechanic here that has some idea about japan cars, only the MAZDA showroom will know something but about this model i think they dont know much, and the ...

Thank you very much for the info, i will try this. I will post the results. Thanks again.

Hy again,
I tried to tune the idle with the TPS but the measurments are ok. I put the car in DIAG mode but nothing changed, only the colling fan started to work, i removed the plug, and then i tried again with the idle screw, but nothing. The car is stil arround 1300-1500rpm, the fuel consumption ...

Thanks for the help, i tried to locate them but i did not fiind them, i will trie again to fiind them. Do you know how to flush them, what kiind of liquid to use or maybe another thing.
Thanks again

Hy,
I have a problem with my mx-3, when it rains in the back of the driver seat, there is a lot of water :( . I dont have rust under the car in the area. I saw this problem after i greased the sunroof, with heat resistant grease and W40, because i want'it to work smoth. But i dont know if this is ...

Anyone?

Hy, i am not sure but i think many do, but only when the strut mount is also the steering pivot. The bearing is a wear item and affects the steering response as well as wheel alignment.

I will try to remove the air filter to see what happens, and if not i will go to a mechanic-electrician with the expleain from here to show him wat to do, because i dont want to mess anithing there. If i screw some parts i can't fiind any to buy, or is very expensive.
Last night at the races i ...

Hy guys, sorry for the absents, but i had a lot of work, and i don't remember the pasword of the id to conect from my mobile :oops: .
I want to thank every one for the help. I checkt the level of coolant, it's almowst full, i tried with TEN and GND with a led to see if something show, but nothing ...

Hy, thanks for the answer.
1. The cable has a little slack, i tried that.
2. The throttle body is ok, i cleaned, before mounting.

The car was ok, after the instal, only after a few hard drives, it started to idle spot on at 2000rpm, and some times 1500-1600rpm, and after i played with the screw ...

U Your only supposed to adjust the idle screw with the TEN and GND jumped with a wire or a paper clip (so the car is in diagnostic mode)
Can you explain this procedure a litle, because i am new with this type of cars. The strut bar is mazdaspeed i bought the car with it, i dont know if that was ...

I have put the MAF back. I tried today to ajust the idle from that screw on top but i only go to 1200rpm and the screw is full closed. Can the catalyts be the problem because i removed? I tried to take out the negative wire, and whait 15min press the brake pedal a few times, and then start the ...

Hy guys.
I have a problem with my mx3. I have changed the air filter with a BMC Twin Air, and made some adaptions, but all the hoses are put back, and removed the catalizator. I changed the fuel filter, but i think this can't be a problem. When i started the car the idle was normal, but after a few ...

I posted in V6 tehnical section, maybe here is not corect.

Hy everyone, sorry for the absents but i had a lot of work.
The part with the fuel consumption is down at 10L/100km in city, and the idle is down wen the engine is warm at 800+-100. Today i left my car at a tunner to make some modifications, when i got the car back the idle is at normal, but after ...