MX-3.com

Thanks everyone, yeah am from uk, spec of car is as follows

KLZE Straightneck
Uprated HT leads
Stainless headers & de cat & 2.5" exhaust
CAI (fogs removed and air filter relocated to hole left by fog lamp)
KLZE ecu
K8 Flywheel & Gearbox
Green stuff brake pads / drilled/grooved discs all round ...

Here you go

Heres some pics

http://i660.photobucket.com/albums/uu327/paulie73_album/PB130271.jpg

http://i660.photobucket.com/albums/uu327/paulie73_album/PB130272.jpg

http://i660.photobucket.com/albums/uu327/paulie73_album/PB130275.jpg

this is what she used to look like

http://i660.photobucket.com ...

Have taken the bloody things off the car, but I will put put them back on at weekend and take some pics to show exactly what problem is.................

Can't post picture as I have taken shocks off. Let me try and explain better.......

When I bought car it had stock suspension fitted with lowering springs.
Have bought k sport coilovers, when fitting them I measured ride height from stock shocks and set them up to be 2" lower than stock suspension ...

Hey everyone, am from the uk, have got some issues with my new k sport coilovers. Think I have been sent the wrong ones, I think I have had 323 ones sent instead, The issues I have are that the rear tyres are not clearing the springs, the inside diameter of the springs are 2.5" and they are approx 9 ...

Sorry should have said, she is a manual

My speedo is not working on car. It was working before I cut wire on ecu to remove limiter. The speedo then bounced up and down eractically when on test run and now does not move at all. On way to the road, I opened the gas up on a bumpy car park and car bounced about a bit, so I was wondering ...

I connected the wire back up today and the speedo still does not work Any ideas? could it be the impellor that connects to gearbox? Have my doubts as speedo was fine until I cut wire, but seeing as I have reconnected wire and speedo still does not work its now doing my head in.

ok thank you, will check tomorrow to see if I have cut wrong one!

Sorry limiter kicks in 112mph TYPO!

Hi Everybody!! Am from the united kingdom, have just installed a KLZE straight neck with KL36 ecu & JE50 vaf.

Got a problem. The bloody limiter kicks in at 122mph. :(

I have followed instructions from looking on here and I cut the wire on the 22 pin block, top row 5th from left. it was black and ...