Page 1 of 1
holes in bumper ---->how to fill ????
Posted: May 9th, 2004, 10:46 am
by bander_as
hey guys,
I was wondering what product should i use and how to use it to fill two holes holes in front bumber from the license plate.
thanx
Re: holes in bumper ---->how to fill ????
Posted: May 9th, 2004, 12:36 pm
by tical
puddy is bout the only thing that will stick to that plastic bumper, but i think it will just crack over time.... but if the holes bother u that bad, then id just go with a kit....
Re: holes in bumper ---->how to fill ????
Posted: May 9th, 2004, 2:06 pm
by TekPmp
Perhaps some epoxy and hardener? sand around the holes to bare polyurethane on both sides, apply generously on both sides then sand it down flush in front. This would only be practical for small screw holes though.