MX-3.com

I have finally tracked down a KLZE engine in the uk i get it next week. Problem is he doesnt have the ECU for it. I can however get a ecu with the code KL55-18-881B is this from a KLZE engine. i have searched but have found no info on the ecus

Just email Lazzie (Layzzie? how do you spell it??) -- he can get them for you.

<small>[ May 25, 2004, 12:02 PM: Message edited by: atlantamx3 ]</small>

i can find lazzie (layzzie) email address so if any one knows it please post it to me so i can try and get a ECU

I think it's Lazzyie

Yah, lazzyie is correct and also is his AIM ID. Dunno about an email address though. PM might work best here...

Yeah, PM him. Might take a few days, but he'll respond.

Or you could always email Lazzyie directly from one of his recent posts. He has that feature enabled... just the email addy is hidden.

Just in case you can't get hold of him, try Dastek for a custom mapped ecu, thats what i have and it kicks

Just in case you can't get hold of him, try Dastek for a custom mapped ecu, thats what i have and it kicks

Originally posted by UKMX-3:
Just in case you can't get hold of him, try Dastek for a custom mapped ecu, thats what i have and it kicks

How much did that set you back?
Does it allow the VRIS points to be adjusted?

allibath if you part out the engine i need all of the pulley's >>> how much did the ze set you back> bet it wasn't cheap

the engine cost me £800 with 6 months warrant (unlimited miles) i will be sell bits off my 1.8 engine so make me offers . I wont be selling the fly wheel cause if you add the 1.8 fly wheel to the 2.5 it make the response alot better

Originally posted by alibath:
the engine cost me £800 with 6 months warrant (unlimited miles)

That sounds really good. Where did you get it from?

OK, I`ve apperently got a KLZE,im going to check it out this weekend.I have 3 questions
1.As the differance between the final gear ratio`s is not massive is it possible to run a KLZE on a K08 gearbox?

2.Is it possible to just re-map my K08 ECU rather than hunt around for ages for a KLZE ECU?

3.Can anybody give a clue to deviation in engine No`s to identify the KLZE. I have allready read the some of the descriptions on the net and all I seem to be able to find is a description of the "squared off" Throttle body? Any assistance for a positive ID would be greatly appreciated.....
ta

#2: As I said before, you can get an ECU from Lazzyie on this site. I think he charges ~$260.
#3: It should have squared off intake runners. Do you have a straight neck IM or a curved one? If its a ZE: If it's straight, it should have KL-31 stamped on the cams; if it's curved, it should have KL-01. Remove your valve covers to see.
Good luck with that.