MX-3.com

sorry for the long delay. the iac is my suspect. even the local mazda shop thinks that its likely the problem. and considering the $ tag on a new one, i'll live with it

ok, so i get home today and my mx3 is sitting in the driveway and the lights are on... no one has touched it in a week and the happened between 730 and 930 am today. its been one of those days today so i was tempted to fix it with 1/2 pound of H.E. went through most of the site and phoned the local ...

LOL! i have wires just like that on my b6d. where did you get you heat shield?... i want one. mines rusted

XD +1 to christexan. laughed so hard at that

so, i recently seafoamed my tb, used the TEn and GND method to adjust the idle (went up 500rpm after cleaning) and set it to 1000 rpm. everything was normal till today, it is rainy and cool. it started fine, but when i went to drive off after about 2 mins of idle, it acted like it did when i had a b...

i cant get mine to show the codes for some reason... the engine light comes on and stays on unless i start it(with or without pins jumped)

i cant find a screw on my tb anywhere... help? have 96 stock 4 cyl injected

lol perhaps you can look at my car?

where are you located? I live in saskatoon and if your in the area I will be happy to look at it for you free of charge, I am a journeyman heavy equipment mechanic with about 13 years of automotive experience, so I know what I am doing no BS.

i dont have the KLZE engine...i dont think so anyway... but i am in saskatoon and just got an mx3 (96 red 4cyl) anyone got any solutions to the wonky idle/ stalling at lights problem?

how do you reset the throttle position sensor?

i just got my car(96 mx3, 4cyl DOHC) and it nearly stalls when i push the clutch in and it only does it when its warm. it may be a leak after the airflow sensor because i had to duct tape it *tear* but i dont think that it is the problem... any steps to fix this would be great