I'm hoping to acquire an MS ecu in the next few months, and in preparation for that have downloaded TunerStudio.

I'm trying to figure out the software as best I can, while learning about tuning in general. The amount of information is staggering, and I was hoping to dig through a couple of existing tunes, and compare/contrast to see where people had successes with their own projects.

If you've tuned a K8(NA, not boosted), and have your files saved, I would be extremely grateful for the opportunity to take a look at them!

It's kind of a shot in the dark, as most people swap to a KL prior to tuning, but this is the best shot I have of finding what I'm looking for.

Thanks!

Bump, hoping for some luck here...

Seriously, bumpity bump bump for a K8 Tune!!!

Seriously, who would waste money to put Megaquirt on a K8

Someone planning to swap down the road, that prefers to risk blowing the K8 over a built KL...? It comes down to economics, and it's honestly not that strange.

You should be able to start with a base map from an NA KL, it might be a bit easier to find. It'll more than likely be a bit on the rich side, but at least it'll put you alot closer than a turbo map. This might be helpful:
http://forums.probetalk.com/showthread.php?t=1701288659

I had started to mess with a KL tune, but TunerStudio wasn't reading it properly(didn't know which firmware the tune had been created with, it gave multiple errors).

Thanks for that link Redline, I had been looking for that thread -.- PT search is useless.

Yep, just use a KL base map and just change the required fuel, that will get you started.

Awesome, will do!