Donate to the MX-3.com Forums
View unanswered posts | View active topics It is currently November 14 2019, 2:44 PM



Reply to topic  [ 3 posts ] 
 AEM Fuel and Ignition Controller wiring 
Author Message
Regular Member

Joined: September 02 2011, 11:11 AM
Posts: 56
Reply with quote
Post AEM Fuel and Ignition Controller wiring
I think whoever wrote the electical diagram for the ECU should be beat with a sack of oranges. (Rant aside)

I recently purchased an AEM F/IC for $160 brand new local. Good deal, and pretty much gives me everything I could need (for now). However, there's a lack of MX-3 ECU wiring diagrams.

I think I've got them all, but I'd like some second opinions. All of the connections are being made near the ECU on the wiring harness.

Fuel Injectors (1-6): orange, yellow/violet, yellow/black, orange/white, yellow/black, gray
O2 sensors: blue/white, white
TPS: green/yellow
Crank position sensor: light gray (?)
G and NE1: purple/green, purple white
VAF: ???
IAT: red/black

Crank position sensor I am unsure of. It's a pain and a half trying to understand that schematic on the electrical diagram.

More specifically for the VAF, which wire is for airflow? May use the MAP or add a MAF and have an analog output simulate the VAF, so need to know.

Please and thank you.

_________________
Black 1993 Mazda MX-3 GS - daily driver
Kenwood BT-948HD, MB Quart FX4.100 and ONX1.1000D, Polk MM6501 x4, Polk MM1240
SE interior, MOMO Endurance shift boot, Tomei long shift knob, eBay short shifter

Red 1987 Toyota MR2 - go kart

"If it's crazy you want, it's crazy you get."


July 14 2012, 12:26 AM
Profile
Regular Member

Joined: October 08 2009, 12:36 PM
Posts: 855
Location: United Kingdom
Reply with quote
Post Re: AEM Fuel and Ignition Controller wiring
I have just wired in a AEM to my 1600, although I cannot give you specifics! Get a multimeter and make up some long reach probes for it then you can test which wires from the engine sensors go to the ECU plugs. We found the schematics to be quite helpfull really alot of the wire colours where the same just the wires in slightly different locations on the plug, not surprising really mine being a UK car.

_________________
Image


August 06 2012, 2:10 AM
Profile
Senior Member
User avatar

Joined: April 09 2007, 1:26 PM
Posts: 2400
Location: Calgary, AB
Reply with quote
Post Re: AEM Fuel and Ignition Controller wiring
I did pretty much the exact same thing. - Had to make my own ecu diagrams that very way (as the 96 is a b1tch)


August 06 2012, 1:04 PM
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 3 posts ] 

Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.