for swapping the clutch do I have to take the whole motor and tranny out together or is it easier to lower the tranny down by itself while having the car on stands? I don't have a hoist but I have stands and jacks. Ps my car is slammed, its very very low..


I have the KLZE with stock K8 clutch and fly wheel ( I didn't have money for a clutch when I swapped it)

and I am looking for a clutch and flywheel setup that is light and can hold 260 hp

I think I found one that will work and fit, but I don't know here it is
http://www.ebay.com/itm/PROBE-MX-6-626-MX-3-2-5L-NONTURBO-eCLUTCHMASTER-STAGE-2-RACING-CLUTCH-KIT-/380407265468?pt=Motors_Car_Truck_Parts_Accessories&fits=Make%3AMazda%7CModel%3AMX-3&hash=item58920a38bc&vxp=mtr

and for the flywheel.. do I Have to machine it down? well I don't have anything to do that unless I could orbital sand it down??

Just get your flywheel checked and machined if required as it's already a light flywheel then check out Exedy clutches. Don't buy a clutch from Ebay. IMO

The transmission can be lowered out the bottom... in my opinion thats the easiest way..

Pro tip:
Quality products are generally not purchased through ebay.

eclutchmasters is not clutchmasters.

If it's cheap, it's cheap for a reason.
If you want quality... then make sure you buy from a reputable source.